Assembling & Installation Instructions

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
Fig.1
B
C
D
A
MOUNTING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker box. Remove old
fixture and all hardware from Junction Box.
2. Carefully unpack your new fixture and lay out all the
parts
on a clear area. T
ake care not to lose any small parts
necessary for
installation.
3. Thread the tw
o Studs about 1/4”into the pre-drilled holes in
the mounting plate spaced the same distance apart as the
holes in the plate (A).
4. Attach the mounting
plate to the
Junction Box with the two
Junction Box Screws as shown. The side of the mounting
plate marked "GND" must face
out.
5. While holding the plate(A
) assembly towards the cei
ling,
connect the
electrical wir
es as Shown in Fig.2, making
sure that all wire nuts are
secured. You may have to
wrap
the connectio
ns with electrical tape. If your outlet h
as a
ground wire (green or bare copper), connect the fixture
groun
d wire to it. Otherwise connect fixture’s ground
wire directly to the Mounting strap with the green screw
provided. After wires are connected, tuck them care
fully
inside the Jun
c
tion Box.
6. Raise the plate (A) onto
the junction box, aligning
screws
on m
ounting plate with mounting hol
es in plate (A) and
lock it securely with the ball nut (C).
7. Install the light
bulbs in accordance with the fixture’s
specifications. NOTE: DO NOT EXCEED THE
SPECIFIED WATTAGE.
8. Slide the hook (B) to right until becomi
ng, then raise
glass(D) into the hooks.
NOT
E:
You can also use another way to install the
lamp, please see fig.3.
Y
our installation is now complete. Return power to the
junction box and test the fixture.
Fig.3
plastic
anchors
wood
screw
ceiling
Fig.2
MIN 90℃ SUPPLY CONDUCTORS
White or
HOUSE
Black
WIRES
(Hot)
Smooth
FIXTURE
WIRES
Black or
Ribbed
WIRES
FIXTURE
Bare Copper(Ground)
FIXTURE
WIRES
Copper
(Ground)
HOUSE
(Neutral)
WIRES
White
Bare
Green or
WIRES
HOUSE
ASSEMBLING & INSTALLATION INSTRUCTIONS
For Ceiling Mount Fixtures