Installation & Assembly

For Customer Service, contact the place of purchase to arrange for replacement parts.

5. Use Chain connector (H) to attach the top of Chain (I) to

the Canopy loop (A2) and close the chain connector as

shown.

6. Tread the fixtrue wires through the center hole in Canopy

loop.

7. Make sure the weight of the chandelier will be supported

by the chain-not the electrical wire.

* You may now install the fixture.

2. Use Chain connector (H) to attach the Chain (I) to top

curve of fixture Frame (J) and close the connector as shown.

3. Attach a Chain connector (K) to the top end of the Chain

(J). Repeat steps 1 thru 3 for the second chain.

4. Lace the fixture’s wire through the chain links (I) (every

three links) and pull until taut.

(the wires will run through just one side.)

Fig 2

Note: Complete these remaining steps after the fixture is

hung.

8. Place the Glass Shades (M) over the Threaded Sockets

(L), secure the Glass Shades (M) by threading by the Socket

Rings (O) over the socket washers (N) until tight.

9. Install the light bulbs in accordance with the fixture's

specifications.

(DO NOT EXCEED MAXIMUM WATTAGE RATING)

Fig 3

PARTS & ASSEMBLY SHEET