Installation and Assembly

ASSEMBLY INSTRUCTION

NOTE: Please consult a qualified electrician if you are not certain of the installation or service.

CAUTION: Before starting the installation or service, disconnect the power by turning off the

circuit breaker or by removing the fuse at the fuse box.

1. Carefully unpack the fixture, lay out all parts on a clean surface.

2. Fasten the cross bar onto the outlet box by using provided 2 outlet box screws.

3. Tie ground wire from outlet box and from fixture to the ground screw on the cross bar. Connect white

wire from fixture to white wire (neutral wire) from supply circuit. Connect black wire from fixture to

black wire (live wire) from supply circuit. Cover connections using provided wire connectors.

4. Place the fixture body to the wall by aligning the protruding mounting screws all the way through the

wall plate and tighten ball nuts to the mounting screws until the fixture body is held firmly against the

wall.

5. Unscrew the snuffer and socket ring from the socket. Place the glass over the socket; refasten the snuffer

and socket ring to secure the shade.

6. Install the bulb (Not included).

7. Turn on the power. This fixture can be installed as an up-light or a down-light position.

PAGE 1
ASSEMBLY INSTRUCTION NOTE: Please consult a qualified electrician if you are not certain of the installation or service. CAUTION: Before starting the installation or service, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box. 1. Carefully unpack the fixture, lay out all parts on a clean surface. 2. Fasten the cross bar onto the outlet box by using provided 2 outlet box screws. 3.
PAGE 2
INSTRUCCIÓN DE ASAMBLEA NOTE: Por favor, Consulte con un electricista cafificado en caso de que esté seguro de la instalación. CAUCIÓN: Antes de comenzar la instalación, cortar la electricidad mediante apagar el cortacircuitos o quitar el fusible desde la caja de fusible. 1. Desempaquetar cuidadosamente la instalación, disponer todas las piezas sobre una superficie límpia. 2. Acoplar la barre Cruzada a la Caja de salida usando los Tornillos de la Caja de salida que se proporcionan. 3.