Installation & Assembly

Step1: Drill Holes in Wall for screws or screw anchors and attached Mounting plate to Wall
Determine your desired location for installation and make a mark for the location of the mounting plate and . Remove
mounting plate from backplate by loosening set screw in backplate as pictured below. Place center hole of mounting plate
over mark made above. Make 2 marks where mounting screws will be placed as shown below. Drill hole at each of the mark.
(You may substitute other style mounting anchors or screws if desired). Place anchors into the holes made. Place mounting
plate over holes and secure to mounting surface using screws as shown below.
INSTALLATION INSTRUCTIONS
MOUNTING PLATE
DRILLED HOLES
PERSPECTIVE
BACKPLATE
SET SCREW
MOUNTING PLATE
SCREW
WALL ANCHOR
DRILLED HOLE
DETAIL A
A