Owner Manual - Table

ManualsBrandsRed Barrel Studio ManualsOutdoor & Patio FurnitureRound 2 - Person 27.5'' Long Bistro Set with Cushions

Table Of Contents

Caution: This Table is NOT a TOY

Keep your child/ children at bay during the assembly process.

Whenever moving/lifting the Table and to prevent damage to the Table, two

adults are needed to execute these actions.

Assembly Instructions

Caution: You must read this before you proceed

Table

Page 1 of 7

Please look

underneath

the

able

op for hardware packs.

Summary of content (7 pages)

PAGE 1
Assembly Instructions Caution: You must read this before you proceed Please look underneath the table top for hardware packs. Table Caution: This Table is NOT a TOY Keep your child/ children at bay during the assembly process. Whenever moving/lifting the Table and to prevent damage to the Table, two adults are needed to execute these actions.
PAGE 2
Parts List Label Picture Description QTY A Table Top 1 B Leg 4 Description QTY ① Bolt (M8x50mm) 9 ② Washer 9 ③ Allen Key 1 Hardware Label Picture Page 2 of 7
PAGE 3
Assembly Preparation Before Beginning Assembly: Page 3 of 7
PAGE 4
Assembly Steps Overview Table Top (A) Leg (B) This Table has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Table parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly. Step 1 Unpack and place all parts on a clean non -marring surface.
PAGE 5
Step 2 B A 2 1 3 Attach Leg(B) to the Table Top(A) using Bolts(①), and Washers(③) with Allen Key(④). Do not fully tighten the Bolts. Repeat the same process with the remaining three Legs(B).
PAGE 6
Step 3 Stand the Table up, with assistance from your adult partner. Exert pressure floorwards, onto the Table with both your hands. This pressure will help the Legs and Table Top reach full alignment status. Check for wobbles on a LEVEL surface. If no wobbles are found proceed to tighten the Bolts in a sequential manner, until evenly secured. When tightening the Bolts tighten sequentially. Do not tighten any Bolt fully and then move on towards the next one.
PAGE 7
Page 7 of 7