Installation Instruction

We hope you will find these instructions helpful in setting up your product.
The pump must be fully submersed at all times to avoid pump burnout.
Product must be properly stored for winter.
The final assembly should
look like this
Gently lower the top in place.
Operating Instructions
For complete operating instructions, please see the included manual.
1. Install the included batteries.
2. Attach the included stake to the panel.
3. Fully charge the unit with the included charging cable or a minimum of 6
hours of direct sunlight.
4. Connect the pump to the corresponding socket on the panel.
5. Place the panel in a location where it will obtain consistent direct
sunlight.
6. Fill the fountain with clean water.
7. Turn the device on by pressing the power button.
8. Toggle the device to the desired method of operation: Direct solar or
Battery Power.
Direct Solar Power is the default method of operation. Battery Powered
operation will work for a period of up to 4 hours with a full charge.
Pass the big plug cord down
the pipe in the bowl.
Pass the small plug cord down
the pipe in the bowl.
Carefully rest the bowl on its side.Feed the power cord down the
pedestal and out the base.Align the power cord with the groove at
the base of the pedestal.
Carefully lower the bowl on to
pedestal.Align the grooves,
twist and lock the bowl to
the pedestal.
Connect the tubing from the
top to the pump.
The final product.
SOLAR FOUNTAIN INSTALLATION INSTRUCTION