Installation & Assembly

ManualsBrandsRed Barrel Studio ManualsLightingTymon Black Brushed Iron 2-Bulb Outdoor Flush Mount

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

Turn off the power at fuse or circuit box.

Page 1

Mounting Strap (A)

Short Screw (B)

Green Grounding

Screw (C)

Lock Nut (F)

Wire Nut (E)

Hardware Package (included):

Assembly Instructions:

1. Thread two long screws to the mounting strap, and secure

with two lock nuts. Adjust the length of the long screws if

necessary.

2. Attach the mounting strap to the outlet box using two short

screws.

3. Pull out the source wires from the outlet box. Make wire

connections using wire nuts as follows:

---Connect the hot wire (usually black insulation) from the

fixture to the black wire from the power source.

---Connect the neutral wire (usually white insulation) from

the fixture to the white wire from the power source.

---Attach the fixture grounding wire (usually bare wire) to the

mounting strap with the green grounding screw, then

connect it to the house grounding wire with a wire nut. If your

outlet box does not have a house grounding wire, then wrap

the fixture grounding wire around the green grounding screw.

Carefully put the wires back into the outlet box.

Long Screw (D)

Socket

Set screw

Ball Nut(G)

Canopy

Outlet Box

House Grounding Wire

Wire Nut (E)

Short Screw (B)

Mounting Strap (A)

Green Grounding Screw (C)

Lock Nut (F)

Long Screw (D)

Bulb Type A Max.60W

(not included)

Bottom

Glass Panel

Side Glass Panel

Side Glass

Panel

Ball Nut (G)

Metal Frame

Bottom Glass panel

“L” Slot

Metal Stop

“S” Clip

Fig.1

Fig.3

Fig.2

WARNING: Turn off the main power at circuit breaker before installing fixture.

AVERTISSEMENT: Coupez la source d’alimentation principale au panneau

central de disjoncteurs avant d’installer le luminaire.

Summary of content (2 pages)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: Turn off the main power at circuit breaker before installing fixture. AVERTISSEMENT: Coupez la source d’alimentation principale au panneau central de disjoncteurs avant d’installer le luminaire. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS. Hardware Package (included): Mounting Strap (A) Fig.
PAGE 2
4. Attach the canopy to the mounting strap: insert the long screws through the two holes, and secure it with two ball nuts. CAUTION: With silicone caulking compound, caulk completely around where back of canopy meets with the ceiling surface to prevent water from seeping into the outlet box. 5. Install bulbs (not included). See relamping label at socket area or packaging for maximum allowed wattage. 6.