Owner's Instructions Manual

Part K.
SAFETY INFORMATION
USING YOUR FIRE TABLE / COLUMN
Before each use, inspect the Gas Hose (12). Replace Gas Hose(12) if there are any signs of cutting, wear
or abrasion.
Before you light your Fire Table / Column, please proceed / adopt the following steps :
1.
M
ake sure the Control Knob (13) is in the “OFF” position.
2.
O
pen the Door (07) and slowly open the Valve ( 22) on the Propane Gas Tank by turning the Contol
Knob (13) counterclockwise.
3.
Cl
ose the Door (07) on the Main Frame (06) of the Fire Table / Column.
4. Push and hold in the Electronic Ignitor (14 ) to create sparks within the electrode continue to hold.
5.
Push i
n the Control Knob (13) and turn to the “LOW” position.
Keep holding down the Control Knob (13) to allow gas to flow for 15 seconds.
6.
I
f ignition doesn’t occur within a few seconds release the Control Knob (13) and rotate to the “OFF”
position.
Wait for 5 minutes for gas to clear and then repeat the above lighting instructions.
7.
On
ce the Fire Table / Column is lit, the flame intensity may be controlled by turning the Control Knob
(13) between the “LOW” and “HIGH” positions.
8.
O
bserve flame height when lit:
8.1. ) Flame color should be yellow / blue.
8.2. ) Flame height burns at 2 - 10 inches high.