Owner Manual

INSTALLING THE LED ASSEMBLY AND GLASS SHADE
10
|
1
2
4
5
3
WARNING: Before starting installation, disconnect the power by turning off
the circuit breaker or removing the fuse at fuse box. Turning power off
using the fan switch is not sufficient to prevent electric shock.
Remove the 1 of 3 screws from the posts of the light kit decora
tive housing and keep it for future use. Loosen the other 2
screws. (Do not remove)
While holding the LED assembly under your fan, make the polarize
plug connections: (Fig. 2)
- Red to white
- Black to black
Place the key holes on the LED assembly over the 2 screws
previously loosened, turn the LED assembly until it locks in place at
the narrow section of the key holes. Secure by tightening the 2
screws previously loosened and the one previously removed. (Fig. 1)
Raise glass shade up against mounting plate and secure it to the
fan by turning the glass shade clockwise until snug. DO NOT
OVERTIGHTEN.
Restore power and your light kit is ready for operation.
Fig. 1
Fig. 2
Mounting Plate
Glass
Shade
Screws
Wire Connectors
Mounting Plate
LED
Assembly