8 of 8
PARTS AND HARDWARE Avoid using sharp objects such as a knife to cut open packing as you may accidentally damage the upholstery. M8 Washer (Outer Dim. 22mm) 8x M8 x 90mm Threaded Rod 8x M8 Plastic Cap (Ouder Dim. 20mm) 8x IMPORTANT Ensure that the support legs are extended out (behind the backrest) when using it as a bed. M8 Nut A 8x Spanner x1 Accessing Storage Compartment Simply lift the sofa seat cushion up from the front. Keep closed at all times.
OPERATING YOUR UNIT Converting to Sofa Standing at the side of the unit (from bed position), lift backrest to the desired position and secure in place by releasing to the sound of a click. ASSEMBLY INSTRUCTIONS CAUTION: At least two adults are required to safely complete performing this task. Other lifting attempts may risk back injury due to large and heavy part(s). Carefully place sofa body unit on a clean flat surface as below. Unpack hardware from the storage compartment.
Locate pre-drilled holes on the side of storage body and match the orientation with the correct armrest. Now, carefully join armrest (with the four threaded rods exposed) with storage body by aligning and going through the four pre-drilled holes at the side of storage body. Repeat step for other armrest, ensuring both are fully secured. Secure all four threaded bolts with washers and nuts from inside with spanner, making sure there is no movement. Use the plastic cap to conceal expose threaded rod.