Instruction manual

Build 31 v31.6.16 Beta

50 50

STEP PRINT

Specifies the number of times each single frame captured in Time-lapse mode is to be recorded to the

digital media. Range is 1 to 10 frames. Default setting is 1 frames. To adjust: Select STEP PRINT and

twist joystick to change the highlighted NUM FRAMES box to the desired setting (default is 1 frame.)

INTERVAL

Specifies the number of seconds the camera will wait before the next image is captured. Range is 1 to

1024 seconds. Default setting is 5 sec. To adjust: Select INTERVAL and twist joystick to change the hig-

hlighted PERIOD box to the desired setting (default is 5 seconds.)

BURST TYPE

Burst type specifies the type of burst recording. To adjust: Select BURST TYPE and twist joystick to

change the highlighted FRAMES ARE box to REPEATED or UNIQUE. Default setting is REPEATED.

REPEATED: Specifies that each frame captured during the burst record be repeated. That is for each

Time-lapse event, a single frame is repeated N times, where N is the Step print value.

UNIQUE: Specifies that each frame captured during the burst record is unique. That is for each Time-

lapse event, N frames are captured and recorded, where N is the Step print value.

NOTE: When recording in Time-lapse mode, the RECORD tally lamp will remain illuminated.

Each successive event uses the next available Edge Code and Timecode value and uses the existing clip

name. This results in a complete Time-lapse sequence with a single clip name and correct timecode se-

quence. To exit Time-lapse mode, push the RECORD button.