SDS

_____________________________________________________________________________________________
RD-0035 - Vinyl Spackling Compound; Patch-a-Wall
Revision Date: 01-Oct-2017
Soda lime borosilicate glass
65997-17-3
TWA: 1 fiber/cm3 respirable
fibers: length >5 µm, aspect ratio
>=3:1, as determined by the
membrane filter method at
400-450X magnification [4-mm
objective], using phase-contrast
illumination
TWA: 5 mg/m
3
inhalable fraction
- -
Quartz TWA: 0.025 mg/m
3
respirable
fraction
(vacated) TWA: 0.1 mg/m
3
respirable dust
: (30)/(%SiO2 + 2) mg/m
3
TWA
total dust
: (250)/(%SiO2 + 5) mppcf TWA
respirable fraction
: (10)/(%SiO2 + 2) mg/m
3
TWA
respirable fraction
IDLH: 50 mg/m
3
respirable dust
TWA: 0.05 mg/m
3
respirable
dust
Other Information
Delayed Hazards: Calcium Carbonate filler (1317-65-3) can cause lung damage. If product
sanded, appropriate respirator should be worn to avoid breathing dust. Pre-existing
respiratory disorders may be aggravated by exposure. Trace levels of Silica, Crystalline
(14808-60-7) (as Quartz) is present in Calcium Carbonate filler. This material can cause
cancer. If sanded, this material may generate silica dust. Inhaled silica has been classified
by IARC as a human carcinogen. Soda Lime Borosilicate (65997-17-3) can cause lung
damage. If product sanded, appropriate respirator should be worn to avoid breathing dust.
Pre-existing respiratory disorders may be aggravated by exposure.
Appropriate engineering controls
Engineering Controls
If airborne contaminants are generated when material is heated or handled, sufficient
ventilation in volume & air flow patterns should be provided to keep air contaminant
concentration levels below limits specified.
Individual protection measures, such as personal protective equipment
Eye/Face Protection
Use approved safety goggles or safety glasses. If necessary, refer to appropriate
regulations & standards.
Skin and Body Protection
Wear impervious gloves as required to prevent skin contact.
Respiratory Protection
When air contaminants may exceed acceptable criteria, use NIOSH/MSHA approved
respiratory protection equipment. Respirators should be selected based on the form &
concentration of contaminants in air in accordance w/ OSHA laws & regulations or other
applicable standards or guidelines, including ANSI standards regarding respiratory
protection.
General Hygiene Considerations
Handle in accordance with good industrial hygiene and safety practice.
9. PHYSICAL AND CHEMICAL PROPERTIES
Information on basic physical and chemical properties
Physical State
Paste
Appearance
White to slightly off-white
Odor
Mild, characteristic latex
Color
White to slightly off-white
Odor Threshold
Not determined
Property
Note: The information below is not
intended for use in preparing
product specifications
Remarks • Method
pH
_____________________________________________________________________________________________
7.5-9.5 @ 25 °C (77 °F)
Melting Point/Freezing Point
Not determined
Page 4 / 9
Boiling Point/Boiling Range
Not available