Specifications

RED DSMC OPERATION GUIDE

955-0020_V5.1, REV-A | 124

PIN SIGNAL DESCRIPTION

1 +VBATT Power input, +11.5 to +17 V DC

2 +VBATT N/A

3 SCL-BATT Serial Battery Bus Clock

4 GROUND Power Return (Camera Ground)

5 GROUND N/A

6 SCA-BATT Serial Battery Bus Data

WARNING: It is very important that both pairs of +VBATT and GROUND pins are wired up. DO NOT fabricate

power cables with just one each of +VBATT and GROUND pins wired, as this may cause damage to the cam-

era’s power supply; this is not covered by Warranty.

NOTE: Two pre-fabricated DC Power input cables are available from RED Digital Cinema.

 P/N 790-0138 – DC Power – RED BRICK

QUICKPLATE to Camera – 18 in. (0.5m)

 P/N 790-0164 – DC Power – XLR to Camera – 10 ft. (3m)

HDMI OUT

The HDMI output supports an HDTV and PC monitor compatible 10-bit 4:2:2 progressive scan video signal

(with embedded audio) at 720p and 1080p resolution.

In addition to video data, the HDMI output also provides 4 channels of embedded audio.

NOTE: Default setting is PREVIEW.

NOTE: HDMI video output is Progressive Scan; it does not support 1080i or 1080PsF modes.

SIDE SSD MODULE

The SIDE SSD MODULE mounts to the left side of the camera Brain. On the rear face of this module is a slot for

inserting a REDMAG 1.8”SSD digital Magazine. Do not attempt to insert any other media type, or any foreign

objects into this slot, as damage to the SIDE SSD MODULE and/or the camera Brain may occur.

The VIEWFINDER output Module on the front face of the SIDE SSD MODULE provides digital video, communi-

cations and power interconnection between the camera and a RED EVF or RED LCD digital display. Due to the

requirement for absolute data integrity this requires a custom cable manufactured by RED, the pin-out of this

SIDE SSD MODULE