Specifications

RED DSMC OPERATION GUIDE

955-0020_V5.1, REV-A | 16

INSTALL SIDE HANDLE

WARNING: The SIDE HANDLE is NOT HOT SWAPPABLE, meaning you cannot remove or install the SIDE HAN-

DLE while the camera is powered on. Before installing or removing the SIDE HANDLE, you MUST power down

the camera. Failure to do so may result in damage to the SIDE HANDLE or DSMC that will not be covered under

warranty.

REQUIRED TOOL: T10 Torx

driver

1. Power down the camera.

2. Use a T10 Torx driver to remove the single screw located at the bottom of the brain side plate (if installed).

3. Rotate the brain side plate upwards to disengage the lip at the top of the side plate from the camera brain,

and remove the brain side plate.

4. Insert the lip at the top of the SIDE HANDLE into the area where the lip from the brain side plate was in-

stalled.

5. Press the SIDE HANDLE down flush along side of camera brain.

6. Rotate the thumbscrew upward while applying steady pressure until tight.

REMOVE SIDE HANDLE

WARNING: The SIDE HANDLE is NOT HOT SWAPPABLE, meaning you cannot remove or install the SIDE HAN-

DLE while the camera is powered on. Before installing or removing the SIDE HANDLE, you MUST power down

the camera. Failure to do so may result in damage to the SIDE HANDLE or DSMC that will not be covered under

warranty.

1. Power down the camera.

2. Rotate the thumbscrew downward until the SIDE HANDLE detaches from the camera body.

3. Pull the bottom of the SIDE HANDLE away from the brain to disengage the lip at the top of the SIDE HAN-

DLE away from the camera brain.

4. Remove the SIDE HANDLE from the camera.

DSMC MODULES

WARNING: The DSMC modules are NOT HOT SWAPPABLE, meaning you cannot remove or install the modules

while the camera is powered on. Before installing or removing modules, you MUST power down the camera.

Failure to do so may result in damage to the modules or DSMC that will not be covered under warranty.

PRO I/O MODULE

The PRO I/O MODULE brings together the essential I/O connections into one module, providing a central hub

for professional audio and video components.

 Centralized ports make it easy to manage connections and cables.

 LCD/EVF port allows you to connect an additional RED LCD or EVF.

 Customize triggers and interface with third-party GPIO and RS232 control devices using RED PRO I/O

cables.

 Attach an additional DSMC module or a REDMOTE to the back of the PRO I/O MODULE for additional ex-

pansion.