Specifications

COPYRIGHT © 2013 RED.COM, INC
RED DSMC OPERATION GUIDE
955-0020_V5.1, REV-A | 52
 Double-Click Left 25% to Start AF: Double-tap the left 25% of the video area on the LCD to start autofocus
when compatible lenses are used. For a list of compatible lenses, go to “Supported Lenses” on page 126.
OTHER
 Lock Touch Screen: Touches to the LCD are locked out. To unlock, touch the screen and follow the on-screen
instructions.
 Use Small Dialogs on 9” LCD: The dialogs on the RED TOUCH 9.0” LCD are smaller than the default dialogs.
 EVF Tally Light: The Record Tally Red LED on the EVF lights when recording.
DISPLAY MODES
Settings in this screen determine how different settings display on the main screen.
EXPOSURE
 Time (Absolute): Displays the exposure time in seconds (1/xx sec). When you change the frame rate in this
mode, the shutter time stays the same, but the shutter angle changes. This is the default.
 Angle (Relative): Displays the exposure as an angle (1–360 degrees). When you change the frame rate in this
mode, the shutter angle stays the same, but the exposure time changes.
NOTE: While you cannot select a shutter speed that is outside of the capability of the camera, you can select a
shutter speed that is not currently possible and use that as a target shutter speed. After you change a control-
ling parameter, you can use the target shutter speed.
APERTURE
 1/4 F#: Aperture spinner shows 1/4 stops.
 1/3 F#: Aperture spinner shows 1/3 stops. This is the default.
FOCUS DISTANCE
 Metric: Displays lens focus distances in meters.
 Imperial: Displays lens focus distances in feet and inches. This is the default.
REMAINING POWER
 Current Batt %: Displays the remaining percentage of active battery. This is the default.
 Total Time: Displays the total run-time left of battery power, taking into account all available batteries.
VU METER SOURCE
 Input: Displays levels of audio inputs (pre-mixer). This is the default.
 Output: Displays levels of audio outputs (post-mixer).
HISTOGRAM
 RGB: Displays red, green, and blue channels on histogram. This is the default.
 Luma: Displays luma channel on histogram.
MOTION MOUNT ND
Only applicable when using a DSMC
®
RED MOTION MOUNT
TM
.
Select how the ND value displays in the top left corner of the main screen.
 Fraction: Displays the neutral density value as a fraction of light transmission. This is the default.
 Density: Displays the neutral density value as an optical density value.
 Stop: Displays the neutral density value as a stop loss.