User Guide

POWER PORTS
DC IN (POWER INPUT)
The following devices feature a DC IN connector:
DSMC2 Base Expander
DSMC2 V-Lock I/O Expander
DSMC2 Jetpack Expander
DSMC2 Jetpack-SDI Expander
DSMC2 REDVOLT Expander
DSMC2 Production Module
The 6-Pin 1B DC-IN connector accepts DC input power from 11.5 V DC to 17 V DC. A built-in power conditioner
protects against reverse- polarity connections, electrostatic discharge (ESD), undervoltage, overvoltage, and
overcurrent.
WARNING: Both pairs of +VBATT and GROUND pins must be wired. Using a third-party power cable that wires only
one (1) pair of +VBATT and GROUND pins may damage the power supply or the camera. Damage to the power
supply or other components of the camera system caused by using an inappropriate power cable is not covered
under warranty.
Figure: Front Face of the DC In Power Input Connector (Looking at the Camera)
6-PIN 1B DC INPUT CONNECTOR
PIN SIGNAL DESCRIPTION
1 +VBATT Power input, +11.5 to +17 V DC
2 +VBATT Power input, +11.5 to +17 V DC
3 SCL-BATT Serial battery bus clock
4 GROUND Power return (camera ground)
5 GROUND Power return (camera ground)
6 SDA-BATT Serial battery bus data
NOTE: Mating connector is FGJ.1B.306.CWLD72Z.
C OPYRI GHT © 2019 R E D.C OM , LLC 955-0 1 6 7_V 7.1, REV- M | 242
DSMC2 MONSTRO OPERATION GUIDE