Installation guide
Chapter 3.
Installing and Configuring Red Hat Cluster
Suite Software
This chapter describes how to install and configure Red Hat Cluster Suite software and
consists of the following sections:
• Section 3.1 Software Installation and Configuration Tasks
• Section 3.2 Overview of the Cluster Configuration Tool
• Section 3.3 Installing the Red Hat Cluster Suite Packages
• Section 3.4 Starting the Cluster Configuration Tool
• Section 3.5 Naming The Cluster
• Section 3.6 Configuring Fence Devices
• Section 3.7 Adding and Deleting Members
• Section 3.8 Configuring a Failover Domain
• Section 3.9 Adding Cluster Resources
• Section 3.10 Adding a Cluster Service to the Cluster
• Section 3.11 Propagating The Configuration File: New Cluster
• Section 3.12 Starting the Cluster Software
3.1. Software Installation and Configuration Tasks
Installing and configuring Red Hat Cluster Suite software consists of the following steps:
1. Installing Red Hat Cluster Suite software.
Refer to Section 3.3 Installing the Red Hat Cluster Suite Packages.
2. Starting the Cluster Configuration Tool.
a. Creating a new configuration file or using an existing one.
b. Choose locking: either DLM or GULM.
Refer to Section 3.4 Starting the Cluster Configuration Tool.
3. Naming the cluster. Refer to Section 3.5 Naming The Cluster.
4. Creating fence devices. Refer to Section 3.6 Configuring Fence Devices.