Installation guide

104 NetIQ eDirectory 8.8 SP8 Installation Guide
15 Use the cluster manager to move the shared storage to the secondary node.
16 Use the eDirectory installer to perform an unattended installation of eDirectory on the
secondary node. Ensure that the mode of installation is
install .
17 In the terminal, navigate to the location of the configuration utility on the secondary node. The
utility is located in the eDirectory installation folder by default.
18 Run the following command:
dsclusterconfig.exe -s /<sharedfilesystem>
Where <sharedfilesystem> is the cluster shared storage. The path of the <sharedfilesystem>
should be same as the path location specified when the primary node was configured.
19 The dsclusterconfig utility updates registry on the secondary cluster node to the shared
eDirectory data located on the shared cluster file system.
20 After the configuration utility finishes configuring the secondary node, open the NDSCons
utility.
21 In the NDSCons utility, click Startup.
22 Click Ye s to confirm.
23 When NDSCons starts all eDirectory services, verify eDirectory, then click Shutdown.
24 Click Ye s to confirm.
25 To configure eDirectory in the Cluster Resource group, create a new resource in the Resource
Group to be used for eDirectory.
You must provide the following details:
 Resource type - Generic Service
 Dependent on - IP address and shared disk in the Resource Group
 Service name -
NDS Server0
 No start parameters
 Registry keys -
SYSTEM\CurrentControlSet\Services\NDS Server0
NOTE: Ideally, the cluster manager checks that the same DIB is not accessed by two or more nodes
simultaneously. However, you must ensure that ndsd does not run from two or more cluster nodes
simultaneously. This is because accessing the same DIB through two or more nodes leads to DIB
corruption.
10.2.3 Configuring SNMP Server in Clustered Windows Environments
1 On the primary cluster node, configure the master agent and set the startup type to automatic.
For more information, see “Installing and Configuring SNMP Services for eDirectory” in the
NetIQ eDirectory 8.8 SP8 Administration Guide.
2 Save the eDirectory password when it prompts for the password.
3 Start the sub-agent.
4 Perform Step 1 to Step 3 on the other nodes.