Installation guide

Installing eDirectory on Linux and Windows with IPv6 Addresses 73
4.1.4 Adding LDAP URLS for IPV6 on the LDAP Server Object
If you do not specify the LDAP URLs during the initial eDirectory configuration, you can use the
ldapconfig command or iManager to add them in the ldapInterfaces attribute.
The following are examples for using the
ldapconfig set and the ldapconfig -s command:
ldapconfig set "ldapInterfaces=ldap://[2015::3]:389,ldaps://[2015::3]:636"
ldapconfig -s
"ldapInterfaces=ldap://[2015::3]:389,ldapInterfaces=ldaps://[2015::3]:636"
To add LDAP URLs in iManager:
1 In NetIQ iManager, click Roles and Tasks.
2 Click LDAP > LDAP Options.
3 Click View LDAP Server, then click the name of an LDAP Server object to configure.
4 Click Connections, add LDAP URLS in the LDAP Interfaces field.
5 Click Apply, then click OK.
4.2 Installing or Upgrading eDirectory on Windows with IPv6
This section provides information about configuring eDirectory on a Windows computer that already
supports IPv6 addresses.
4.2.1 Enabling IPv6 While Installing or Upgrading eDirectory
If you want to use IPv6 addresses, ensure that you select the Enable IPv6 check box under IPv6
Preference during the eDirectory installation. If you select it, the DHost starts listening on the IPv6
addresses. If you do not enable IPv6 addresses during the installation process, and then decide to use
them later, you must run the setup program again.
4.2.2 Enabling IPv6 for Existing Servers
If you want to use IPv6 addresses for an already configured eDirectory server, you must rerun the
installation and select the Enable IPv6 check box under IPv6 Preference. It enables the NCP, HTTP, and
HTTPS protocols for the IPv6 addresses.
4.2.3 Accessing iMonitor
You can access iMontior over IPv6 addresses using the following link:
http://[2015::3]:8028/nds