User guide

2121
4-INSTALLATION AND ASSEMBLY4-INSTALLATION AND ASSEMBLY
Technical Dept. - All rights reserved - Reproduction is prohibited
Therefore, the end user is responsible for product storage, disposal or possible recycling in compliance with the relative
applicable laws. Position the product without its cladding and connect it to the chimney. Once the connections are complete, assemble
the cladding (steel sides).
If the product must be connected to an exhaust pipe that goes through the rear wall (to enter the chimney), make sure not to force it in.
Adjust the 4 feet (J) to level the boiler so that the smoke exhaust and the pipe are coaxial. The ceramic sides must not be tted when the
feet are adjusted as this is carried out inside the cladding.
Attention!!
If the boiler smoke outlet is forced or used improperly to lift it or position it, the operation of the boiler can be
damaged irreparably.
FOOT J1. TURN THE FEET CLOCKWISE TO LOWER THE PRODUCT.
2. TURN THE FEET ANTI-CLOCKWISE TO RAISE THE PRODUCT.