Specifications

RED SCARLET-X OPERATION GUIDE

955-0003_v4.0, Rev-A | 49

ICON BEHAVIOR

CAL:T/E



T or E Green - No change in sensor temperature or exposure from the levels recorded during calibration



T or E Yellow - Slight change in sensor temperature or exposure from the levels recorded during

calibration



T or E Red - Significant change in sensor temperature or exposure from the levels recorded during

calibration



The - and + indicate whether the sensor temperature or exposure has decreased or increased

NOTE: The T and E change colors independently of each other.



TC Gray - No analog time code is currently detected



TC Red - Analog time code is being detected, but the use of it is not enabled



TC Green - Analog time code is being used to jam the time of day time code. TC will revert to gray if the

signal is no longer detected

GEN



GEN Gray - No genlock signal is currently detected, or the presented signal cannot crosslock to project

(24.00 fps vs. 23.98 fps)



GEN Red - During process of sync, or if genlock is lost while recording



GEN Green - A genlock signal matching the current HD-SDI monitor rate has been locked to it



GEN Yellow - When timing is cross-locking to compatible but not matching monitor rate. i.e. genlock =

24.00, HD-SDI monitor rate = 25.00

NOTE: 3D operation should not be done if GEN is yellow. This is a warning that genlock source settings and

camera settings are not aligned. Phasing of the sync between cameras cannot be guaranteed when GEN is

yellow.

SYNC



SYNC Gray - The sensor sync mode is not Genlock



SYNC Red - The sensor sync mode is Genlock, but it is not locked to any genlock signal, or genlock or

sensor sync is lost while recording



SYNC Green - A genlock signal compatible with the HD-SDI monitor rate has been locked to and the

sensor timing is also locked to it