Specifications

RED DSMC OPERATION GUIDE

955-0020_V5.2, REV-C | 80

CANON AND NIKON LENS SETTINGS

The settings below display when a DSMC Nikon Mount, DSMC Canon Mount, or DSMC Canon MOTION MOUNT

is installed with a supported lens.

 Aperture: Enter the F-stop value. The range and default depend on the attached lens.

 Focus: Enter the focal distance. The default value is the value read from the lens. The range depends on

the attached lens.

MOTION MOUNT TAB

NOTE: The Motion Mount menu is only accessible when a DSMC

RED MOTION MOUNT

is installed. For more

information about using the MOTION MOUNT, see the DSMC MOTION MOUNT Operation Guide, available at

www.red.com/downloads.

1. Navigate to Settings > Setup > Lens > Motion Mount.

2. Select one of the following Motion Mount settings from the Shutter Type drop-down menu:

‒ ND Only: The MOTION MOUNT functions only as an ND filter.

‒ Soft: The MOTION MOUNT soft shutter takes over shuttering duties, and the MOTION MOUNT contin-

ues to function as an ND filter.

‒ Square: The MOTION MOUNT square shutter takes over shuttering duties, and the MOTION MOUNT

continues to function as an ND filter.

MOTOR CONTROL

GENERAL

The General tab provides status information for currently connected motor control modules, as well as enables

you to select the appropriate serial communication protocol and initialize all connected motors.

FOCUS, IRIS, AND ZOOM

The Focus, Iris, and Zoom tabs are reserved for future use.

WIRELESS

The wireless tab allows you to enable the wireless controller of a connected device to communicate with the

DSMC. You can also select the channel and power settings appropriate for the environment. The wireless signal

strength is also displayed as a percentage.