Specifications

206 206

APPENDIX F: 3D SETUP / OPERATION

OVERVIEW

The following information outlines basic procedures to connect two RED DSMC cameras together in a

Master / Slave configuration for 3D operation, operation of cameras in Master / Slave configuration and

clip naming conventions for clips recorded on those cameras. The MASTER camera will control only the

METADATA parameters of both cameras. On the SLAVE camera, any other setting outside of these will

need to be manually changed before recording.

CAMERA SETUP

Select one camera to be designated as Master and a second to be designated as Slave.

NOTE: Cameras can also be set up in a MASTER / MASTER and SLAVE / SLAVE configuration. To

set as MASTER / MASTER select ALL under TARGET for both cameras. This will allow either

camera to make METADATA changes and control record start/stop of both cameras. To set as

SLAVE / SLAVE select NONE under TARGET for both cameras. This allows each camera to

control its own METADATA.

MASTER CAMERA

Perform the following steps on the Master camera:

1. Go to SECONDARY MENUS > SETTINGS > SETUP > COMMUNICATION > NAME and give the

camera a unique NAME (CAM A, LEFT, etc…).

2. Under TARGET select ALL.

3. Give the camera a unique IP address.

4. Go to SLAVE CAMERA.