Specifications

26 26

INSTALLATION / REMOVAL

WARNING: THE SIDE HANDLE IS NOT HOT SWAPPABLE - MEANING YOU CANNOT REMOVE OR

INSTALL WHILE THE CAMERA IS POWERED ON. BEFORE INSTALLING OR REMOVING THE SIDE

HANDLE, YOU MUST POWER DOWN THE CAMERA. FAILURE TO DO SO MAY RESULT IN

DAMAGE TO THE SIDE HANDLE AND / OR CAMERA BRAIN THAT IS NOT COVERED BY

WARRANTY.

To install the side handle:

1. Power down the camera if necessary.

2. Remove the brain side plate (if installed) by removing the single screw located at the bottom.

3. Rotate upwards to disengage lip at top of side plate from camera brain.

4. Insert the lip at the top of the side handle into the area where the lip from the side plate was installed.

5. Rotate side handle down flush along side of camera brain.

6. Rotate thumbscrew upwards until tight. Ensure side handle is secure to camera brain. You may have

to apply steady pressure to get the screw started.

Remove screw and rotate side

plate upwards to remove.

Insert lip into top of

camera brain.

Press side handle flush

against camera brain.

Rotate thumbscrew

upwards until tight.