Instruction Manual
COPYRIGHT © 2015 RED.COM, INC
RED DSMC OPERATION GUIDE
955-0020_V5.3, REV-J | 188
# CONNECTOR CONNECTOR TYPE FOR MORE INFORMATION, GO TO...
1 REDMOTE Dock 8-point POGO “REDMOTE Operation” on page 140
2 Module Power SEARAY “Power Inputs” on page 32
3 HD-SDI BNC “HD-SDI Out” on page 188
4 HDMI HDMI “HDMI Out” on page 189
5 Headphone Jack 3.5mm stereo “Headphone” on page 189
6 SYNC 4-pin 00B LEMO “SYNC (Video Sync In)” on page 190
7 CTRL 4-pin 00B LEMO “CTRL (RS232 Control)” on page 191
8 GIG-E 9-pin 0B LEMO “GIG-E (Ethernet)” on page 192
9 DC IN 6-pin 1B LEMO “DC IN (Power Input)” on page 193
N/A MIC-1, MIC-2 (Front) 3.5 mm stereo “MIC-1, MIC-2 (Microphone Audio)” on page 194
HD-SDI OUT
A standard 75 ohm BNC connector provides the following output:
Broadcast specification HD-SDI video output (default mode is Clean)
Two (2) channels of embedded audio
Time of Day and Edge timecode
Record Tally flag
Clip name information (as SMPTE RP-188 VITC2 HANC metadata)
For more information, go to “Monitor” on page 67.
The HD-SDI output provides the formats described in the table below:
HD-SDI OUTPUT FORMATS
1
VIDEO FEED
2
FREQUENCY (HZ)
3
SMPTE STANDARD
720p 23.98, 24.00, 25.00, 29.97, 30.00, 50.00, 59.94 ST 292-1 (1.485 Gbps)
1080p 10-bit 4:2:2 23.98, 24.00, 25.00, 29.97, 30.00 ST 292-1 (1.485 Gbps)
1080p 10-bit 4:2:2 50.00, 59.94, 60.00 ST 424 (2.970 Gbps)
1. Ensure you select a frequency supported by your monitor.
2. The HD-SDI output is progressive scan (p); it does not support progressive segmented frame (PsF) or interlaced (i) scan formats.
3. The frequency options depend on project time base. If you have a non-drop frame project time base (such as 24.00), you can select
only non-drop frame frequencies. If you have a drop frame project time base (such as 23.98), you can select only drop frame frequencies.
75 OHM BNC CONNECTOR (HD-SDI)
PIN SIGNAL DESCRIPTION DIRECTION
Center HD-SDI SMPTE ST 424 HD-SDI Out
Shield/Screen GROUND Camera ground N/A
COMPATIBLE CABLE
790-0341: RED HD-SDI Cable (6')