Operation Manual

205 205

CHARGING

CHARGE TIME

A fully discharged REDMOTE battery will be fully charged in approximately 6 hours.

USING CAMERA

While connected to the camera, the REDMOTE will automatically recharge its internal battery. Charge

status is indicated by the Green Battery Icon at the top-right of the REDMOTE LCD display screen. A

fully discharged REDMOTE battery will be re-charged in approximately 6 hours if connected to a

powered camera or a USB based power source such as laptop P.C.

USING USB CONNECTOR

The REDMOTE can be charged by connecting the RED Mini-USB-to-USB cable (790-0230) between

REDMOTE and a computer or a cell phone charger.

NOTE: The REDMOTE can be charged using the Mini-USB connector while connected and controlling a

camera wirelessly.

NOTE: If the computer / cable / hub do not provide enough voltage, the REDMOTE will not charge

and show an "Error Charging" message.

1. Connect the USB connector to any computer (computer must be ON to charge REDMOTE).

2. Connect the Mini-USB end to the REDMOTE USB Port located on the lower right side (under rubber

protective cover).

3. If the REDMOTE is powered down (and paired camera is OFF), the REDMOTE will power UP, display

STARTING UP, display SEARCHING (with flashing Green LED), then settle into IDLE mode.

4. Green battery indicator will blink, indicating REDMOTE is charging.

5. A fully discharged REDMOTE battery will be fully charged in approximately 6 hours.