Operation Manual

955-0002_v3.3, Rev-B COPYRIGHT © 2012 RED.cm, Inc.
35 35
2. Rotate module down flush with the rear of the adaptor plate.
3. While applying steady pressure to hold the module against the adaptor plate, use a T-20 Torx
screwdriver to rotate the lock on the adapter plate clockwise to secure the module.
Installation is now complete.
To remove the DSMC Module and Adaptor Plate:
1. Power down the camera.
2. Use a T-20 Torx screwdriver to rotate the lock on the adapter plate to the Unlock position.
3. Rotate the module upwards and down to disengage lip at top of battery from adaptor plate.
4. Remove module from adapter plate.
Rotate Lock Clockwise
Until Red Dot Lines Up
with Lock Icon
Press Module Flush
with Adaptor