Installation manual

2-INSTALLATION INSTRUCTIONS

PELLET STOVE INSTALLATION EXAMPLE

Always use pipes and ttings with appropriate seals that guarantee tightness.

It must be possible to inspect all sections of the ue duct and they must be removable for periodic internal cleaning (T-tting with

inspection hole).

Position the product considering all the above requirements and instructions.

IIMPORTANT!

The following conditions must be complied with when connecting the appliance to the chimney:

• The smoke duct must be at least category T200 (or higher if required by the smoke temperature of the appliance)

and P1-type (airtight).

• All 90° angles (max. 3) in the smoke exhaust duct must be preferably tted with the relative T-ttings with

inspection hole. (See pellet product accessories).

• It is strictly forbidden to t a mesh at the end of the exhaust pipe as it could cause the product to malfunction

(due to clogging).

• It is forbidden to use counter-sloping pipes.

• The horizontal section of the smoke duct must not be longer than 2-3 m.

• It is also recommended not to exceed 6 metres in length with the pipe Ø 80 mm.

• The smoke duct must not cross rooms in which it is forbidden to install combustion appliances.

COMBUSTION AIR (2)

During operation a certain amount of air is drawn from the room in which the product is installed and this air must be supplemented

through an external air inlet.