Installation manual

3-INSTALLATION AND ASSEMBLY

Room ventilation can only be set towards the rear wall if there is adequate insulated ducting of the hot air ow.

The air outlet pipe can become very hot, approx. 200 °C: therefore, it must be adequately insulated with suitable

material, especially points that could come in contact with ammable surfaces or parts that are aected by heat

(e.g. change in shades, wiring ducts, plasterboard, etc.). Moreover, persons and animals must be protected from

accidental or intentional contact. In any case, comply with the regulations and laws in force in the region where the

product is installed.

It is recommended to insulate the entire length of the pipe in order to reduce dispersion and increase heat output

in the room.

PLATE

SCREW “A”

FIG. 5 - KNOB BLOCKING SCREW

FIG. 4 - AIR DIRECTION KNOB

KNOB