Installation manual
28
4-OPERATION
BEFORE START-UP
GENERAL PRECAUTIONS
Remove all components that could burn from the rebox of the stove and the glass (instructions, various adhesive labels and any
polystyrene).
Check that the brazier is positioned correctly and rests properly on the base.
After a long period of inactivity, remove any pellets left in the hopper (using a vacuum cleaner with a long pipe), as they
could have absorbed moisture, thereby altering their original characteristics and no longer being suitable for combustion.
The rst start-up may not be successful as the feed screw is empty and does not always manage to load the required
amount of pellets in the brazier in time for the re to be regularly ignited.
CANCEL THE FAILED START-UP ALARM STATUS BY PRESSING KEY D FOR A FEW SECONDS. REMOVE THE PELLETS FROM THE
BRAZIER AND REPEAT START-UP.
If a ame does not ignite after a number of failed start-ups, even though the pellet supply is correct, make sure the brazier is set in place
correctly, which must be interlocked in its seat and clean from any ash deposits. If no anomaly is found during this inspection, there may
be a problem with the stove components or installation may not be correct.
REMOVE THE PELLETS FROM THE BRAZIER AND CONTACT AN AUTHORISED TECHNICIAN.
Avoid touching the stove during the initial start-up, as the paint hardens during this phase. If you touch the paint,
the steel surface may be exposed.
If necessary, touch up the paint with the spray can of the specic colour. (see “Pellet stove accessories”)