Installation manual

4-OPERATION

It is good practice to guarantee eective ventilation in the room during the initial start-up, as the stove will emit

some smoke and smell of paint.

Do not stand close to the stove and air the room. The smoke and smell of paint will disappear after about an hour of operation, however,

they are not harmful in any case.

The stove will be subject to expansion and contraction during the start-up and cooling phases, therefore light creaking noises may be

heard.

This is absolutely normal as the structure is made of laminated steel and must not be considered a defect.

It is extremely important to make sure the stove is not immediately overheated and the temperature is increased gradually starting from

the low power.

This will prevent damaging the ceramic tiles, the welds and the steel structure.

Do not expect heating eciency immediately!

CONTROL PANEL START-UP/SHUTDOWN (key D)

The product is switched on and o by pressing key D on the control panel for 2 seconds.

LED 1 will light up in green and ash during start-up and will remain green and lit when the product is on.

The start-up phase lasts approximately 20 minutes after which the product enters the steady state (LED 1 lights up green

and remains on).

Key D is also used to switch the appliance o.

FEED SCREW LOADING

The FEED SCREW LOADING function can only be activated when the stove is o and allows the pellets to be loaded into the feed screw

(loading system) quickly. It can be used for the initial start-up and each time the pellets nish in the feed screw and hopper (see alarm

LED -1/-2). It is useful to prevent failed start-ups due to the hopper being empty.

The FEED SCREW LOADING function is activated as follows (with the stove o): bring selector “D” on the control panel to OFF and press key

“E” on the same panel three consecutive times. The yellow LEDs above key “E” will start to ash alternately.

Press key “D” once again when the pellets begin to fall into the brazier to end the FEED SCREW LOADING function and proceed with the

stove start-up.