Installation manual
32
4-OPERATION
SELECTING THE PELLET LOADING TYPE (Key E)
This operation allows the user to set the product in the most appropriate way according to the type of pellets available. Therefore,
excessive fuel consumption is avoided, the intended heating capacity is guaranteed and the product integrity is safeguarded. The default
pellet load (0) can be increased or decreased by acting on key E according to the ame characteristics (shape / colour / quality) and the
user’s experience (brazier is too empty or full).
THE TYPE OF LOADING CAN BE SELECTED (default setting 0, -1/-2/+1/+2) UPON THE INITIAL START-UP OR EACH TIME IT
IS NECESSARY. (E.g. when the pellet supplier is changed or when a dierence in colour or size is noticed).
SELECTING THE SMOKE EXTRACTOR SPEED
NIf the installation poses a diculty for smoke evacuation (no draught or no pressure in the duct), the smoke and ash expulsion speed can
be increased. This change resolves all the potential problems related to pellets clogging in the brazier and deposits forming at the bottom
of the brazier itself caused by poor quality fuel or fuel that produces a lot of ashes.
Press keys D and E simultaneously for a few seconds and LED 0 will start to ash: the smoke extractor speed is then increased or decreased
by acting on key E:
• led -2 = -20%.
• Led -1 = -10%.
• Led 0 = default.
• Led +1 = +8%.
• Led +2 = +15%.