Installation manual

4-OPERATION

LED INDICATION TYPE OF PROBLEM SOLUTION

Led  2

The re failed to ignite Check the level of pellets in the hopper. Check that

the brazier rests correctly in its seat and has no visible

deposits of unburned pellets.

Led  1

The re goes o abnormally Check the level of pellets in the hopper. Check that

the brazier rests correctly in its seat and has no visible

deposits of unburned pellets.

Led 0

The pellet hopper temperature exceeds

the intended safety threshold.

The structure overheats due to reduced

heat dissipation.

Triggered pressure switch

Wait for the cooling phase to be completed, cancel the

alarm and restart the product by setting the fuel load

to minimum on LED-2 and increasing the speed of the

room fan (knob A). If the alarm persists, contact the

service centre.

Check and clean the ENTIRE smoke duct-

Protect the outlet from any external wind.

Led +1

Abnormal smoke fan operation Verify that the brazier has no visible deposits of

unburned pellets. If the alarm persists, contact the

service centre.

Led +2

Smoke temperature too high or faulty

smoke probe.

Wait for the cooling phase to be completed, cancel the

alarm and restart the product by setting the fuel load

to minimum on LED-2 and increasing the speed of the

room fan (knob A). If the alarm persists, contact the

service centre.

SHUTDOWN MODE DUE TO AN ALARM

As from when the alarm is triggered, the appliance automatically enters the cooling phase, similar to that of shutdown mode, in order to

guarantee the system is cooled correctly and automatically cleaned.

Simply press key (D) to silence the buzzer without interrupting the cooling phase: the red LED turns orange and ashes and will go o once

the default shutdown temperature is reached.

The majority of the failed start-up and abnormal shutdown alarms can be cancelled by pressing key D once again, thereby switching to a

new ame ignition phase (after having loaded pellets into the hopper). Certain alarms can be cancelled, others require the intervention

of a specialised technician (previous table).

DELETING THE ALARM STATUS

If an alarm is triggered, normal product operation is restored by pressing the on/o key (D). If the cause that triggered he alarm does not

persist, after a brief verication, the product exits the alarm state and can restart.