Installation manual
39
5-MAINTENANCE AND CLEANING
CLEANING THE GLASS
It is recommended to clean the ceramic glass with a dry brush, or if it is very dirty, spray a little specic detergent and clean with a cloth.
ATTENTION!
Do not use abrasive products and do not spray the glass spray cleaner on the painted parts or the door gaskets
(ceramic bre cord).
PERIODIC CLEANING PERFORMED BY A QUALIFIED TECHNICIAN
CLEANING THE HEAT EXCHANGER
The compartment through which the exhaust smoke passes must be cleaned at the of the winter season.
This cleaning process is mandatory in order to facilitate the general removal of all combustion residue, before it becomes very dicult to
remove it due to the humidity compacting it over time.
If necessary, clean it more often.
It is good practice to guarantee eective ventilation in the room while cleaning the product.
CLEANING THE EXCHANGER:
When the stove is cold, open the door, remove plate M (by removing the two screws) and remove brazier “N”; remove the side plates “O”
and “P” by turning them slightly inwards for them to come out of their grooves and then pull them towards you (be careful as they can
break easily).
Once the side plates are removed, lift plate “H” slightly, tilt it downwards and remove it. Then remove the upper plate “Q” by inserting the
cold handle or another tool in slot “Y” on the upper part and lifting plate “Q”. Remove it from its seat by lifting it and then tilting it slightly
downwards. Scrape the walls of the rebox with a rigid rod or a bottle brush into plate “Q” that has just been removed, for the ash to fall
into the lower ash collection compartment.
Once the upper exchanger is cleaned, remove plate “L” after having removed the two screws, and use the nozzle of a vacuum cleaner to
remove the ash and soot accumulated in the lower exchanger and around brazier “N”. Clean and reassemble everything.
CLEANING THE BRAZIER
Technical Dept. - All rights reserved - Reproduction is prohibited