OLPF FRAME INSTALLATION INSTRUCTIONS FOR RED DSMC CAMERAS RED.
OLPF FRAME INSTALLATION INSTRUCTIONS Table of Contents Features Before You Start Read First OLPF Frame Components Tools Required Installing the OLPF Frame Remove the Lens Mount Remove the Old OLPF Frame Install the New Frame Tighten the Screws Install the Lens Mount Disclaimer Copyright Notice Trademark Disclaimer 2 3 3 3 3 3 4 4 5 6 7 8 9 9 9 955-0011, Rev-A1 / COPYRIGHT © 2012 RED.
OLPF FRAME INSTALLATION INSTRUCTIONS Features • Each RED DSMC® Camera has an optical low-pass filter (OLPF) The OLPF frame secures the OPLF to the camera. • RED has designed a new low-profile OPLF frame to accommodate the RED LEICA-M LENS MOUNT. • This new OLPF frame is compatible with all RED DSMC PL, Canon, Nikon, and Leica lens mounts. Before You Start Read First Note: The new OPLF frame must be installed on your camera before using the RED LEICA-M LENS MOUNT.
OLPF FRAME INSTALLATION INSTRUCTIONS Installing the OLPF Frame • Place the camera in a clean indoor environment, free from dust or lint, on a suitable flat working surface, with the front of the camera facing forward. • Remove all accessories and lens as necessary. Remove the Existing Lens Mount Remove the Lens Mount Screws Use Torx T-20 driver Remove the Lens Mount Pull straight out 4 955-0011, Rev-A1 / COPYRIGHT © 2012 RED.
OLPF FRAME INSTALLATION INSTRUCTIONS Remove the Old OLPF Frame Remove the TAMPER SEALS Use tweezers Remove the OPLF FRAME Screws Use included Torx T-4 driver COPYRIGHT © 2012 RED.
OLPF FRAME INSTALLATION INSTRUCTIONS Remove the OLD OLPF FRAME Place the tip of the Torx wrench under the bottom right edge of the OLPF frame to pry it off. Install the New Frame POSITION the NEW OLPF FRAME Place the OLPF Frame into position with the lip on the outer rubber frame and press lightly downward to seat. 6 955-0011, Rev-A1 / COPYRIGHT © 2012 RED.
OLPF FRAME INSTALLATION INSTRUCTIONS Tighten the Screws INSTALL the SCREWS - DO NOT TORQUE Install 4 screws and progressively tighten them in an “X” pattern until finger tight - DO NOT torque at this time. TORQUE the SCREWS Use a torque wrench and tighten each screw to 30 in-oz. If a torque wrench is not available an approximate torque can be achieved by turning the wrench in a clockwise direction approximately 30° beyond snug. (30° is the distance between 12:00 and 1:00 on a clock face.
OLPF FRAME INSTALLATION INSTRUCTIONS Install the Lens Mount Install the Lens Mount Make sure it is seated correctly Tighten the Screws Using a T-20 Torx Driver, seat the four Torx screws very lightly until finger-tight. After all four screws are seated; progressively tighten them in an “X” pattern as shown until hand tight. IMPORTANT: Tighten the screws snug but do not over tighten. Torque the screws to 22 in-lbs if using a torque driver. 8 955-0011, Rev-A1 / COPYRIGHT © 2012 RED.
OLPF FRAME INSTALLATION INSTRUCTIONS Disclaimer RED has made every effort to provide clear and accurate information in these installation instructions, which are provided solely for the user’s information. While thought to be accurate, the information in this document is provided strictly “as is” and RED will not be held responsible for issues arising from typographical errors or user’s interpretation of the language used herein that is different from that intended by RED.
