Manual

Table Of Contents

REDLINK BRIDGE OPERATION GUIDE

955-0064, REV-B | 13

The REDLINK Bridge provides a communication pathway for your app to interface with the DSMC. In order for

this pathway to operate properly, you must enable WiFi in the DSMC and wirelessly connect the REDLINK Bridge

to your device. There are two ways to connect the REDLINK Bridge to a device:

 Ad-Hoc mode: The REDLINK Bridge and your device connect to each other.

 Infrastructure mode: The REDLINK Bridge and your device both connect to an access point, and communi-

cate through that wireless network.

CONNECT VIA AD-HOC MODE

In Ad-Hoc mode, the REDLINK Bridge and your device connect to each other. To connect the REDLINK Bridge

to your device via an ad-hoc network, follow the instructions below:

1. Dock the REDLINK Bridge to the DSMC.

2. Go to Menu > Settings > Setup > Communication.

3. Select the WiFi tab.

4. Select the Enable WiFi check box.

5. Select Ad-Hoc.

6. Select a wireless channel from the WiFi Channel drop-down menu. The default is Ch1, and you can select

one out of 11 channels.

7. Select a security option from the Camera Encryption drop-down menu:

‒ NONE: The connection will be unsecured.

‒ WEP: The connection will be encrypted via WEP.

CONNECT REDLINK BRIDGE

TO AN APP