Manual

REDLINK BRIDGE OPERATION GUIDE
COPYRIGHT © 2014 RED.COM, INC 955-0064, REV-B | 7
REDLINK DEVELOPMENT KIT INCLUDED COMPONENTS
At this time, the REDLINK Bridge is available as part of the REDLINK Development Kit, and is not available as
a standalone item.
The items listed in the table below ship with the REDLINK Development Kit (P/N 720-0028).
ITEM
REDLINK Bridge
USB 2.0 flash drive, pre-loaded with the REDLINK SDK, sample apps, and additional resources
REDLINK Bridge Launch Sequence
HARDWARE AND SYSTEM REQUIREMENTS
NOTE: The REDLINK Bridge requires that your DSMC is on firmware v5.2.8 or later.
REQUIREMENTS FOR CONNECTING TO AN APP
 The app must have been programmed using the REDLINK SDK, which is available through the
REDLINK Development Kit.
 The DSMC must be on firmware v5.2.8 or later.
REQUIREMENTS FOR FOCUS LENS CONTROL
 The T.H.C. must be on firmware v703 or later.
 The Canon or Nikon lens must be electronically supported by the DSMC.
 The DSMC must be on firmware v5.2.8 or later.
ADDITIONAL RESOURCES
The following resources offer additional information about RED, the REDLINK Development Kit, and the RED
community:
 RED.com: Check the official RED website for the latest information about RED products.
 Developer.red.com: Access the lastest version of the REDLINK SDK and all SDK resources from the RED
developer’s portal.
 RED Learn Articles: RED offers in-depth technical articles about RED cameras, post-production, and digital
cinematography.
 RED.com/downloads: Go to the RED Downloads page to download the latest firmware, operation guides,
and post-production software.
 Support.red.com: Check the RED SUPPORT site for FAQs, or to file a support ticket.
 Reduser.net: Discuss all things RED on the REDUSER third-party forum.