Operation Manual

RED DSMC OPERATION GUIDE: WEAPON

SHORT-CUT TO INDUSTRY-STANDARD ANAMORPHIC FORMATS

To quickly access industry-standard anamorphic formats, go to Menu > Settings > Project > Format > Anamorphic.

The Anamorphic tab is a short-cut to all of the industry-standard anamorphic formats, so that you can easily

select the most common anamorphic formats.

The Anamorphic tab lists the anamorphic formats for every format with a 6:5, 5:4, or 4:3 aspect ratio.

NOTE: The Anamorphic tab only lists industry-standard anamorphic formats. To access all of the anamorphic

and non-anamorphic formats, go to Menu > Settings > Project > Format > Format.

LOOKAROUND

When Lookaround is enabled, the Frame Guide and recording area are scaled down on the display so that you

can see what images will enter the recording area.

To assign a Shading overlay to the Lookaround area (the area outside of the recording area), go to “General

Tab” on page 68.

Lookaround limits the available frame rates. At high resolutions, the recording area on the display shows the

full sensor area or full sensor height, so there is no extra room for Lookaround.

AUDIO

The Audio menu lets you configure the audio subsystem. For more information, go to “Record and Monitor

Audio” on page 127.

RECORDING

The Recording menu includes: Mode, Codec, Frame Processing, Pre-Record, and Indicator.

MODE

You can select the following recording modes: Continuous Record, Internal Timelapse Timer, Frame Trigger,

REDCODE Burst, Speed Ramp Mode, Multi-Shot, and Motion + Stills.