Brochure

ManualsBrandsRedarc ManualsBattery Chargers20A In-Vehicle DC Battery Charger

www.redarc.com.au

MADE IN AUSTRALIA

REDARC

In-vehicle

Dual Battery

Chargers

REDARC’s range of In-vehicle Dual Battery Chargers are

designed, built and tested in Australia for our unique

conditions to make sure they won’t let you down.

With features like fully sealed construction and fan-free

cooling - water, dust and vibration are no match for the

In-vehicle Dual Battery Charger... you can be assured they

can handle the roughest tracks in outback Australia and the

deepest water crossings at Cape York.

REDARC’s knowledge of Australian conditions is engineered

into every unit. All models operate up to a market-leading

80°C meaning they are going to work in even the most

extreme heat of the Simpson Desert.

A higher operating temperature and compact in size also

allows for ﬂexible installation options, from the engine bay

to inside a van or camper trailer.

Look at all the beneﬁts…

 Multi-stage charging saves you money

by maximising battery life

 Increase run time of loads like fridges and lights

 Allows for ﬂexible installation in 12 or 24 volt vehicles

 Overcomes voltage drop caused by long cable runs

Built tough for

Australian conditions

Summary of content (4 pages)

PAGE 1
u REDARC In-vehicle Dual Battery Chargers Built tough for Australian conditions ® REDARC’s range of In-vehicle Dual Battery Chargers are designed, built and tested in Australia for our unique conditions to make sure they won’t let you down. With features like fully sealed construction and fan-free cooling - water, dust and vibration are no match for the In-vehicle Dual Battery Charger...
PAGE 2
The BCDC In-vehicle Dual Battery Charger range The REDARC BCDC range features a wide 9-32 volt input range, allowing an auxiliary battery to be charged from either a 12 or 24 volt vehicle electrical system. All models incorporate dual battery isolation as well as fault recognition that includes protection against voltage spikes, overheating and reverse polarity connection, to ensure complete protection of all your batteries.
PAGE 3
With more and more electrical devices being used when travelling around Australia, along with more complex vehicle electrical systems, having the right battery charging solution has never been more important. The REDARC range of BCDC In-vehicle Dual Battery Chargers ensure optimum performance of electrical equipment such as fridges, lights, CPAP machines and even hydraulic pumps when they’re powered from a dual battery setup.
PAGE 4
BCDC1206 typical setup BCDC1220 typical setup Blue wire goes to vehicle ignition for all IGN models or those with 24V input. Note: Power wires must be at least 6mm² and must be crimped using an appropriate crimp tool. Ignition switch All ground points must be connected to chassis earth. Input fuse Loads Anderson Blue wire connects to red wire for plug non-IGN models.