Manual

OPERATING INSTRUCTIONS
Setup Modes (Setup mode is indicated by display of the programming symbol )
ID Select
Mode / Beeps: 1
Selections: 0 to 9 & A to F (16 selections)
For a single gauge setup do not change this selection as only the default selection
“Id.0” allows programming of modes.
Background Colour
Mode / Beeps: 2
Selections: 13 colours
Press and hold to select the programming button to select the colour that the gauge
backlight will display during normal operation. There are 13 different backlight
colour options.
Alert Colour
Mode / Beeps: 3
Selections: 2 Colours (Amber & Red)
Press and hold the programming button to select the colour that the gauge backlight
will change to when an alert is indicated (such as during an over temperature
warning).
EGT Warning Level
Mode / Beeps: 4
Selections: 400°C - 900°C
Press and hold the programming button until the desired warning temperature is
set.
Boost Pressure Display Mode
Mode / Beeps: 5
Selections: 0.0psi or NC
CHANGING THIS SETTING FROM NC TO 0.0PSI WILL RESET THE ZERO OFFSET OF THE
PRESSURE METER. ENSURE THAT THE ENGINE IS OFF WHILST CHANGING THIS SETTING.
If you have enabled the pressure sensor and wish to display pressure set this to
0.0psi, otherwise set to NC.
Boost Warning Level
Mode / Beeps: 6
Selections: 2psi - 30psi
Press and hold the programming button until the desired warning pressure is set.
6
PSI
EGT
X100
BOOST/VAC
0
2
3
4
5
6
7
8
9
10
PSI
EGT
X100
BOOST/VAC
0
2
3
4
5
6
7
8
9
10
PSI
EGT
X100
BOOST/VAC
0
2
3
4
5
6
7
8
9
10
PSI
EGT
X100
BOOST/VAC
0
2
3
4
5
6
7
8
9
10
PSI
EGT
X100
BOOST/VAC
0
2
3
4
5
6
7
8
9
10
PSI
EGT
X100
BOOST/VAC
0
2
3
4
5
6
7
8
9
10