Manual

OPERATING INSTRUCTIONS
Setup Modes
Relay Output Mode
Mode / Beeps: 7
Selections: Boost/EGT/Both/nc
Press and hold the programming button to cycle through which warning will trigger
the relay output.
Note: Grey segment denotes a flashing portion of the Gauge screen during this mode of setup.
RECOMMENDED ACCESSORY: ENHANCED LIGHTING CONTROLLER (GA-ELC)
The REDARC Enhanced Lighting Controller is designed to enhance the lighting of your REDARC gauge. It
is to be used when you do not have a dimming circuit to connect your gauge to or the dimming circuit in
your vehicle does not dim the REDARC gauge to your liking.
The GA-ELC also allows you to program night time brightness and colour of your REDARC gauges,
including dimming if connected to a dash dimmer. Once programmed your gauges will change colour
when turning on your park lights and back to a day light colour when you turn them off.
The GA-ELC is also 24V capable and only one is required for a set of gauges.
Refer to www.redarc.com.au for more details.
7
PSI
EGT
X100
BOOST/VAC
0
2
3
4
5
6
7
8
9
10