Manual

OPERATING INSTRUCTIONS
Setup Modes
(Setup mode is indicated by display of the programming symbol )
ID Select
Mode / Beeps: 1
Selections: 0 to 9 & A to F (16 selections)
For a single gauge setup do not change this selection as only the default selection
“Id.0” allows programming of modes.
Background Colour
Mode / Beeps: 2
Selections: 13 colours
Press and hold to select the programming button to select the colour that the gauge
backlight will display during normal operation. There are 13 different backlight
colour options.
Alert Colour
Mode / Beeps: 3
Selections: 2 Colours (Amber & Red)
Press and hold the programming button to select the colour that the gauge backlight
will change to when an alert is indicated (such as during an over pressure warning).
Low Oil Pressure Warning Level
Mode / Beeps: 4
Selections: 2PSI - 60PSI
Press and hold the programming button until the desired warning pressure is set.
Enable/Disable Optional Temp Sensor display
Mode / Beeps: 5
Selections: Temp or “nc”
Press and hold to toggle between the temperature reading and “nc”. The number
‘-40’ will be displayed if no probe is connected.
Optional Temp Display Reading Adjust (Positive)
Mode / Beeps: 6
Selections: Increments by 1°C every 15 seconds
DO NOT ADJUST THE OPTIONAL TEMP DISPLAY READING UNLESS THE SENSOR IS AT A STABLE
AND KNOWN TEMPERATURE.
Press and hold to slowly increase the temperature reading until it matches the
known temperature of the sensor.
5
0
30
60
90
120
PSI
OIL
C
0
0
30
60
90
120
PSI
OIL
C
0
0
30
60
90
120
PSI
OIL
C
0
0
30
60
90
120
PSI
OIL
C
0
0
30
60
90
120
PSI
OIL
C
0
0
30
60
90
120
PSI
OIL
C
0