Manual

6
OPERATING INSTRUCTIONS
Setup Modes
Optional Temp Display Reading Adjust (Negative)
Mode / Beeps: 7
Selections: Decrements by 1°C every 15 seconds
Press and hold to slowly decrease the temperature reading until it matches the
known temperature of the sensor. The Gauge will display ‘+’/‘-’ dependant on
setting #10.
Optional Temp Display Coarse Warning Level Adjustment
Mode / Beeps: 8
Selections: -40°C to +190°C
Press and hold to adjust the warning level for the Optional Temp Meter display,
release prior to desired level and use fi ne adjust. The Gauge will display ‘+’ or ‘-’
dependant on whether ‘above’ or ‘below’ is chosen in setting # 10.
Optional Temp Display Fine Warning Level Adjustment
Mode / Beeps: 9
Selections: Decrements by 1 through 0-9 values
Press and hold to adjust the warning level for the Optional Temp Meter display, adjust
until desired warning level is reached. The Gauge will display ‘+’ or ‘-’ dependant on
whether ‘above’ or ‘below’ is chosen in mode # 10.
Relay Output & Optional Temp Sensor Warning Mode
THE OPTIONAL OUTPUT RELAY MUST BE CONNECTED TO ACCESS SETTINGS IN THIS STEP.
Mode / Beeps: 10
Selections: ‘+’/‘-’ for above/below, pointers/levels
Press and hold the programming button to cycle through which warning will trigger
the relay output. A number indicates the relay will be triggered by the optional Temp
Sensor. A pointer indicates the respective reading that will trigger the relay. After each
cycle, under(-) or over(+) temp mode is selected. For no relay output, select ‘nc’.
Note: Grey segment denotes a fl ashing portion of the Gauge screen during this mode of setup.
0
30
60
90
120
PSI
OIL
C
0
0
30
60
90
120
PSI
OIL
C
0
0
30
60
90
120
PSI
OIL
C
0
0
30
60
90
120
PSI
OIL
C
0