Product Manual

2
INSTALLATION
Find a suitable location for mounting the Gauge. REDARC offer a range of mounting so-
lutions - see www.redarc.com.au . It is important to ensure that your installation meets
any regulations regarding Field of View and Head Impact requirements.
Wire into vehicle as per the diagram below:
* Connect to a dash light that dims via the vehicle dimmer adjustment to ensure the gauge dims accordingly. If your
illumination circuit in your vehicle varies the positive voltage for dimming you will require an REDARC Enhanced Lighting
Controller (GA-ELC) to get the gauge to dim with your night-time driving lights.
** Ensure that the ground connection makes good contact with the vehicle ground. Poor grounding can cause incorrect
sensor readings. REDARC recommend removing any paint from the surface to ensure a bare metal on metal connection.
It is recommended that any wiring harnesses be covered using conduit or similar.
Multiple Gauge
Communication
Link
G52-TA
Rear View
Programming
Switch
L
O
C
K
A
C
C
O
N
S
T
A
R
T
To Ignition
to Dash Light
Negative*
to Park Light
Positive
Ground
Connection**
2A
fuse
Optional
Relay Output
Temperature
Sensor
Yellow
Green
Black
Orange
Yellow
BlackBlack
Brown
Grey
Purple
2:1 View
Secondary
Connector
2:1 View
Primary
Connector