Product Manual

OPERATING INSTRUCTIONS
Setup Modes (Setup mode is indicated by display of the programming symbol )
ID Select
Mode / Beeps: 1
Selections: 0 to 9 & A to F (16 selections)
For a single gauge setup do not change this selection as only the default selection
“Id.0” allows programming of modes.
Background Colour
Mode / Beeps: 2
Selections: 13 colours
Press and hold to select the programming button to select the colour that the gauge
backlight will display during normal operation. There are 13 different backlight
colour options.
Alert Colour
Mode / Beeps: 3
Selections: 2 Colours (Amber & Red)
Press and hold the programming button to select the colour that the gauge backlight
will change to when an alert is indicated (such as during an over temperature
warning).
Temperature Warning Level
Mode / Beeps: 4
Selections: 30°C - 160°C
Press and hold the programming button until the desired warning pressure is set.
Relay Output Mode
THE OPTIONAL OUTPUT RELAY MUST BE CONNECTED TO ACCESS SETTINGS IN THIS STEP.
Mode / Beeps: 5
Selections: ‘+’/‘-’ for above/below, pointers/levels
Press and hold to set whether the relay will be triggered when the temperature level
alarms. A pointer indicates that the temperature warning will trigger the relay.
Current Sensor Display
Mode / Beeps: 6
Selections: ‘0.0’ or ‘nc’
CHANGING THIS SETTING FROM ‘NC’ TO ‘0.0’ WILL RESET THE ZERO OFFSET OF THE CURRENT
METER. ENSURE THAT NO CURRENT IS FLOWING WHILST CHANGING THIS SETTING.
If you have installed the optional current sensor (GS-AMPS) and wish to display
current, set this to ‘0.0’. Otherwise choose ‘nc’.
4
30
60
90
120
150
A
TEMP
C
0
30
60
90
120
150
A
TEMP
C
0
30
60
90
120
150
A
TEMP
C
0
30
60
90
120
150
A
TEMP
C
0
30
60
90
120
150
A
TEMP
C
0
30
60
90
120
150
A
TEMP
C
0