GS-P-150 GS-P-150 150psi Oil Pressure Sensor GS-P-150
WARNING & SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS - This manual contains IMPORTANT SAFETY INSTRUCTIONS for the 150psi Oil Pressure Sensor. DO NOT OPERATE THE MONITOR UNLESS YOU HAVE READ AND UNDERSTOOD THIS MANUAL AND THE MONITOR AND SENSORS ARE INSTALLED AS PER THESE INSTALLATION INSTRUCTIONS. NOT SUITABLE FOR MARINE APPLICATIONS. 1. The 150psi Oil Pressure Sensor is designed to provide an accurate indication of current.
INSTALLATION The 150psi Oil Pressure Sensor needs to have its 3 wires plugged into the correct positions on your 52mm REDARC Gauge. The 3 wires on the sensor need to be pushed into the holes on the connectors as shown. 1. The Blue wire needs to be pushed into the spare hole on the 7 way. 2. The Green wire needs to be pushed into the end hole on the 6 way connector as shown below. Cut the terminal off and splice the wire onto the existing wire. Make sure you tape the splice after soldering. 3.
TWO YEAR PRODUCT WARRANTY Over the last three decades our company has established a reputation as the power conversion specialist. A 100% Australian-owned company, we have met the needs of customers in transport and other industries through exciting, innovative thinking.
