User Manual

Suitable for: MITSUBISHI PAJERO

FI12045

Issue: 2 Date: 24/05/2018

Kit Part No: TPWKIT-009

Page 13 of

Step 25

Step 26

Step 27

• Route the Cat-5 Cable (1) towards the RHS of the vehicle.

• Using the suppled Cable Ties, secure the Cat-5 Cable (1) every

300mm.

• Insert the Universal Fascia (1) into the previously drilled out hole on

the switch panel (2).

• Insert the Electric Brake Switch (3) into the Universal Fascia (1) from

behind.

• Fasten the supplied Nut (4) locking the Electric Brake Switch (3) to

the Universal Fascia (1). Torque the nut (4) to 0.8Nm.

• Rotate the shaft (5) fully anti-clockwise and fit the knob (6) to the

shaft (5) with “0" pointing upwards as shown.

• Route the Cat-5 Cable (7) to the switch panel area (2) and

connect to the Electric Brake Switch (3) from behind.

5 6

The following step is for vehicle’s with a 3-way connector occupied.

• Disconnect the 3-way connectors.

• Using a jeweller’s flat head screw driver, disengage the 3-way

connector’s secondary lock. Ensure the secondary lock is not

removed from the connector.

• If a connector is already occupying the three way connector (1),

then house the blue and red wires into the mating connector (2)

on the kick panel harness (3) as indicated.

• Re-engage the 3-way connector secondary lock.

Terminal No. Colour

1 BLUE

2 OCCUPIED

RED

Rear of Connector