Use and Care Manual

11
Operation
Switching the Lawn Mower ON/OFF
Switching on
For convenient handling the unit has four On/Off switches on the
handlebar (see Figure 12).
1. Press the switch interlock and hold down
1
.
2. Press any On/Off switch
2
. The motor runs.
Switching off
1. Release the On-/Off-switch
2
(see Figure 13).
After releasing the On/Off switch
the cutter blade continues running briefly.
Battery state of charge (see Figure 14).
The unit has a LED state of charge indicator on the handlebar. In
addition, the charge status can be checked directly on the battery.
1. Press the button to check the state of charge at the state of
charge indicator LEDs. The indicator goes out after 5 seconds. If
one of the LEDs ashes, the battery must be recharged. If none of
the LEDs light up after the button is pressed, the battery is faulty
and must be replaced.
Removing the Grass Catcher (see Figure 15).
If the grass catcher bag is full it should be emptied immediately.
Switch the motor off. Wait until the motor and blades stop.
Lift the discharge ap. Remove the grass catcher. Before
reattaching the catcher, remove any obstructions from the cutting
area. Disconnect the safety key and battery before clearing debris
from the cutting area.
Mowing without the Grass Catcher
When working without the catcher, the mowed grass is ejected
directly downwards.
!
WARNING
Figure 12
Figure 14
Figure 15
1
2
2
2
2
Figure 13
2
2
2
2