Replacement Part List

Operation
This charger can be used with an input voltage of 100-250V and an
AC frequency of 50-60 Hz. To avoid the risk of damage and injury,
only use the charger to recharge Redback 120V battery packs.
Never try to recharge non-rechargeable batteries.
If the charger is plugged in and no LED lights are illuminated, check
that the power cord is rmly plugged into the side of the charger and
that the electrical outlet is live, by testing with a different electrical
appliance. If the charger still does not illuminate, do not use the
charger, and check an authorized service center.
Status indicator lights
The LED light indicates the operating status and the state of charge
of the battery.
LED steady red – the charger is ready to charge, but no battery is
connected
LED ashes green. Battery is charging.
LED steady green: The battery is fully charged and should be
removed.
LED ashes red: battery fault or overheat.
Charging the battery
Plug the charger into an AC outlet 100-250V (normal household
voltage). Insert the battery into the slots of the charger and slide
into place until the battery locks into place. The LED will ash green
while the battery is charging. Once the battery is fully charged, the
LED indicator will show a steady green light. Remove the battery
by pressing and holding the latch button and sliding it out of the
charger. Do not leave the battery on the charger. Remove it when
it is fully charged. Lithium Ion batteries have no memory effect – a
partial charge will not damage your battery
Storage of the charger and battery
For long-term storage (more than 1 month), it is preferable that the
battery is fully charged and stored in a dry place at a temperature
between 50° - 77°F (10–25 °C).
The charger should be stored in the same conditions as the
battery, taking care that no foreign objects such as metal chips
enter through the ventilation slots of the charger. Ensure that the
battery is stored away from anything that might short out the power
connectors on the battery.
!
WARNING
Charger Components
1. Slot for battery
2. Contacts
3. Ventilation slots
4. LED (charge status/fault messages)
5. Socket
6. Power cord