WARNING 1
1. Before Using The RS10XT Thank you for purchasing the Redcat Racing RS10XT rock crawler. The RS10XT is a hobby grade vehicle and is not a toy. Please read the entire manual before attempting to operate this vehicle. Before running the RS10XT, please look over the entire vehicle to ensure there are no damaged or loose parts. Once the vehicle has been used, we can only assume broken parts are a result of improper use. Be sure to check the vehicle over before use. 2.
. Using the 2.4GHz radio system General information -2.4GHz transmitter and receiver. - Full functional, computer transmitter, with LCD screen. - Four steering modes for extreme versatility. -Always remove batteries from this product when not in use. -Do not mix old and new batteries. Do not mix alkaline batteries, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries. Preparation before using -Slide out the battery cover to expose the empty battery compartment.
Full function steering modes This 2.4GHz transmitter contains various steering modes, which are perfect for the rock crawler. Press this button to toggle steering modes. LCD screen on the transmitter Front wheel steering Mode 1 engages front wheel steering only. The rear steering remains straight. LCD screen on the transmitter Four wheel steering - wheels in opposite direction Mode 3 engages 4-wheel steering.
Steering Trim/Steering Reverse Function LCD screen on the transmitter TRM.ST (Steering Trim) range is around 0-100% for both left and right steering on the front wheels. Toggle this switch to select your desired steering trim volume. To Reverse Steering: Press SEL (Select Button) on your radio once, the LCD display appears as Channel 1 (NOR.) Toggle the SWITCH (Steering Trim /Reverse Switch) to change from NOR to REV as shown below: Throttle Trim/Throttle Reverse Switch LCD screen on the transmitter TRM.
Steering Dual Rate (D/R) This lever adjusts the overall travel of the steering servo, push the lever forward for maximum steering. Pull the lever back to reduce steering travel. D/R adjustable range is around 5-100%. LCD screen on the transmitter Trim Switch (For Rear Wheels) This dial is to center the rear wheels. The range is 0-100% in either direction. LCD screen on the transmitter Steering Wheel Controls steering. Turn the wheel to the right and the crawler turns right.
5. ESC And Receiver Placement The RS10XT is a fully assembled RTR vehicle. The following is intended to familiarize you with the placement of electrical components. Electronic Speed Controller (ESC) The ESC is attached to the radio tray with foam mounting tape. If you remove the ESC, clean off the old tape residue and use a new piece of foam mounting tape to re-install. The power switch is secured with two self tapping screws. (2*6mm)- Screw No.: S093 Receiver The 2.
How to bind the receiver with the transmitter? 1) Insert the bind plug into Channel 4 before switching on the receiver. 2) Switch on the receiver. The LED light will flash. 4) Press and hold the SEL button on the transmitter. The LED on the receiver will continue to flash. The radio is binding. When the receiver's LED is lit solid, binding is complete. Note: Repeat the above steps if binding fails. 5) Center the steering trim on the transmitter after binding is complete to set fail safe.
7. Charging the NiMH battery Never tempt to use this charger to charge the batteries of your transmitter. • Only use NiMH specific chargers to charge Ni-MH battery packs. • Never overcharge your Ni-MH battery packs. • Never charge the battery pack unattended. • Always use the battery after it is fully charged. 8. Troubleshooting Guide PROBLEM CAUSE REMEDY Your RS10XT rock crawler 1) Transmitter or receiver is off. 1) Turn both transmitter and receiver on. fails to move.
PART LIST-1 RCT-H001 RCT-H111 Aluminum Side Plate (left/right) RCT-H005 RCT-H112 Upper Link Mounts + Screws 4pcs(Round Head Self Tapping Screw 2.6*8mm) + Screws 2pcs (Round Head Screw 2.5*17mm) + Washers 2pcs (2.5*5.5*0.5) RCT-H007 2P RCT-H010 2P Front/Rear Upper Linkage Ball Stud.(Dia.: 5.8mm) RCT-H009 4P 2P RCT-H017 8P RCT-H008 RCT-H013 Gear Pin-1 (Dia.: 5mm, Length 41mm) RCT-H016 Drive Shaft (front/rear) L=62.5mm Wheel Frame(metal)+Cap Head Aluminum Wheel Hex.
PART LIST-2 RCT-H020A RCT-H021 RCT-H022 3338-H016 2P Spring Pad( Inner Dia.:2.5mm) (apply to motor with screws) Linkage Bar Bolt H007 H009 6P Ball Bearing 5*11*4mm H049 6P Ball Bearing 8*16*5mm RCT-T004 Front/rear Servo Linkage Set +4PCS of Ball Stud. (H016) 11 Gear Shaft Outdrive Cup {front/rear) H016 H032 4P Ball Bearing 10*15*4mm H036 Washer( 2.5*5.5*0.5mm) 8P Washer (3.1*6*0.5mm) 8P 6P Ball Bearing 4*9*4mm RCT-T005 Front/Rear Shock Set 8P 6P Steering Linkage Ball Stud. (Dia.
PART LIST-3 RCT-P002 RCT-P003 Servo Plate+Servo Mount+ Shock Lower Retainer 2P RCT-P008 Front/rear Gear Box Housing + Dust Cover RCT-P011 RCT-P004 RCT-P005 Front/rear Axle Assembly Spur Gear(47T)+Drive Gears+ Gear Gasket + Gear Seal Set + Gear Casing RCT-P060 RCT-P070 Front/rear Steering Hub(left/ right)+ Linkage Set Kit Sero Arm+Power Switch Mount +Antenna Mount H017 H020 2P One Pair Wheel Complete (left/right) Body Post H002 H003 6P Lock Nut M3 6P Flange Lock Nut M4 H021 H153 12P B
PART LIST-4 P019 P100 2P Receiver Antenna Tube HX-2200MH-T RC390 Motor (Rear) Blue Wire (-), Yellow Wire(+) E401 Optional Reachable NiMh Battery Pack 7.2V, 2200mAh HX-15CS Crawler ESC 15KGs Metal Gear Servo S016 S018 12P Set Screw (M3*3mm) 13 E600T U.S. Standard Ni-MH Battery Charger RC390 Motor (Front) Yellow Wire (-), Blue Wire(+) 12P Body Post Pad E600R 01003-CHARGER-T 3CH-24GHz-RADIO E710 3 Channel 2.4GHz Radio with Receiver Receiver RCT-T007 RCT-H106 Optional Front/rear Diff.
PART LIST-5 S030 S031 12P S059 12P 12P Round Head Self Tapping Screw (3*10mm) Cap Head Screw (2*8mm) Round Head Screw (3*8mm) S063 S089 S093 12P 12P Round Head Self Tapping Screw (2.6*6mm) Round Head Self Tapping Screw (2*6mm) S099 S100 S101 12P Round Head Screw (3*14mm) Round Head Screw (2.5*8mm) S104 S027 12P Round Head Screw (3*10mm) Round Head Screw (2.5*10mm) Round Head Screw (2.5*12mm) S098 12P Round Head Screw (3*21mm) S102 12P Round Head Screw (2.
Assembly Diagram-1 Shock Assembly A13: washer (3*6*0.15mm) A14: washer (3*6*0.
Assembly Diagram-2 Front/Rear Spur Gear Assembly 16
CENTER UNIT ASSEMBLY